Surf Pulley Impact Ejector Rig
Click to enlarge |
|
Why pay over $11 elsewhere?
Top quality 80lb test backbone.
Built Tough - NZ made rig with spare trace included.
The Pulley Rig is designed such that a fish picks up the bait and runs with it for about 1.5m before the hook sets.
Clipdown design using our state of the art Genious Impact Ejector clip (aka Impact Shield).
This enables increased distance while casting plus ejects the baited hook when rig hits the water at end of cast.
Your surf sinker clips onto the snap clip below the Impact Ejector and traces simply slip onto the swivel-clip.
Hook sits into the vee slot on the IMPACT clip ready for casting.
Spare Trace supplied with each complete rig.
Lumo Rig beads and Hi Strength thin diameter lines are also used.
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: